CC1311R3 Module, +30dBm, N533HS
- Detail
- Parameters
Radio module based CC1311, PA and LNA. Designed for 169M, 433M, 868M and 915MHz band.
CC1311 module up to 30dBm output power, down to - 113dbm sensitivity at 50Kbps. AT command sopport.
N533HS integrated TI CC1311 chip, which is suitable for 868MHz / 915MHz band. CC1311 module has the characteristics of low cost, low power consumption and small size. The module is designed with 4-layer board, with excellent impedance matching and anti-interference. The module is mainly for Internet of things, intelligent home, wireless meter reading, scientific research and medical treatment, and medium and long-distance wireless communication equipment. CC1311 module leads all pins out for secondary development.
| RF Interface | Parameter | Introduce |
| Frequency | 433M, 860MHz, 960MHz | Support ISM |
| Output Power | +30dBm | The maximum power 25mW |
| Sensitivity | -112dBm | - |
| Symbol Rate | 0.3-4000kbps | Software programming control |
| Deviation | +/-10kHz | Antenna interface |
| Distance | 8000m | In clear and open environment, the antenna gain is 3 dBi, the height above the ground is 2.5 meters, and the air speed is 1.2 kbps. |
| Hardware parameters | Value | Remarks |
| Module Size | 34 x 22 x 3mm | - |
| Antenna Interface | IPEX, stamp hole | - |
| Communication Interface | UART, SPI | Software programming |
| Package | SMD | - |
| Electrical Parameters | Minimum | Typical | Maximum | Remarks |
| Volt | 1.8V | 3.3V | 3.9V | |
| Emission Current | 24mA | Instantaneous power consumption | ||
| Receiving Current | 6.9mA | - | ||
| Sleep current | 1uA | Software programming control | ||
| Working Temperature | -30℃ | 75℃ | - |
Pin Definition
Test method of N533HS module
Take the supporting base plate of Heyan technology as an example:
The bottom board of N533HS is T532AP, which integrates USB to serial chip, led, button, burning port and module card port. As shown in the figure:
N533HS secondary development method:
The CC1311 module is stuck on the backplane as shown in the figure, and the IPEX is connected with the antenna. The burning port is connected with xds110 according to the silk screen printing, and then online simulation can be carried out to test the performance of the module.
Module Programming
The schematic diagram of the module base plate can be obtained from our official website.
Please contact us for specific programming information or download it from TI official website www.ti.com.