CC1120 Module, +30dBm, N513FS
- Detail
- Parameters
Radio moudle based TI CC1120 transceiver ,high power PA, LNA and MCU. Narrowband used.
N513FS CC1120 transceiver high power module designed for 169M, 433M, 868M 915Mhz narrowband. Up to +30 dBm output power, and down to -126dBm sensitivity. AT command used.
N513FS high power module based TI CC1120, ST MCU, PA and LNA. 169M, 433M, 868MHz and 915M narrowband used. Up to 30dBm output power and down to -126dBm sensitivity. AT command used. The module is mainly for Internet of things, intelligent home, wireless meter reading, scientific research and medical treatment, and medium and long-distance wireless communication equipment. CC1120 module leads all pins out for secondary development. AT commands support. N513FS high power Module, SPI and UART port, RF pin, SMD package, small size, the module is suitable for SMT production. N513FS leads uart pins out of for secondary development. Rapid development without understanding RF. N513FS high power module is suitable for free frequency band in EU and USA.
CC1120 Device Introduce
The CC1120 device is a fully integrated single-chip radio transceiver designed for high performance at very low-power and low-voltage operation in cost-effective wireless systems. All filters are integrated, thus removing the need for costly external SAW and IF filters. The device is mainly intended for the ISM (Industrial, Scientific, and Medical) and SRD (Short Range Device) frequency bands at 164–192 MHz, 274–320 MHz, 410–480 MHz, and 820–960 MHz.
The CC1120 device provides extensive hardware support for packet handling, data buffering, burst transmissions, clear channel assessment, link quality indication, and Wake-On-Radio. The main operating parameters of the CC1120 device can be controlled through an SPI interface. In a typical system, the CC1120 device will be used with a microcontroller and only a few external passive components.
ISM Frequency supported by N513FS high power module
169M band: 169 MHz to 170 MHz (China, EU)
433M band: 433 MHz to 435 MHz (China, EU)
470M band: 470 MHz to 480 MHz (China)
868M band: 868 MHz to 870 MHz (China, EU, USA)
888 MHz to 889 MHz (Australia)
915M band: 902 MHz to 928 MHz (USA)
RF rate of N513FS high power module
Narrowband FSK: 0 to 200 Kbps
APPLICATIONS
Sigfox network or point-to-point long distance transmission.
Narrowband system
Arduino device
Narrowband Ultra-Low-Power Wireless Systems
IEEE 802.15.4g Systems
With Channel Spacing Down to 12.5 kHz
Wireless Alarm and Security Systems
169-, 315-, 433-, 868-, 915-, 920-, 950-MHz
Industrial Monitoring and Control ISM/SRD Band
Wireless Healthcare Applications
Wireless Metering and Wireless Smart Grid (AMR and AMI)
Wireless Sensor Networks and Active RFID
Private Mobile Radios
Home and Building Automation
N513FS is suitable for free frequency band in EU and America.
| RF Interface | Parameter |
| Frequency | 169M, 433M, 868M 915Mhz |
| Output Power | +30dBm |
| Sensitivity | -126dBm |
| Symbol Rate | 0.3-200kbps |
| Deviation | +/-1kHz |
| Distance | 15000m |
| Hardware parameters | Value |
| Size | 42 x 24 x 3mm |
| Antenna Interface | IPEX, RF pin |
| Communication Interface | UART, SPI |
| Package | SMD |
| Electrical Parameters | Typical |
| Volt | 3.3V |
| PA Volt | 3.6V |
| Emission Current | 1400mA |
| Receiving Current | 35mA |
| Sleep current | 2uA |
| Working Temperature |
N513FS high power module typical circult
N513FS Pin Definition
Ordering information
N513FS-169M CC1120+mcu+PA+LNA Narrowband, UART, 30dBm, 160M - 175MHz
N513FS-433M CC1120+mcu+PA+LNA Narrowband, UART, 30dBm, 410M - 480MHz
N513FS-868M CC1120+mcu+PA+LNA Narrowband, UART, 30dBm, 860M - 880MHz
N513FS-915M CC1120+mcu+PA+LNA Narrowband, UART, 30dBm, 910M - 960MHz